<\/figure>\n\n\n\nWell yes, LED lights interfere with garage door openers <\/strong>at times. <\/strong>If you notice your garage door is malfunctioning by getting stuck or moving slowly, your LED light may be interfering with your garage door opener. Some LED lights can even block your garage door opener’s electronic frequency causing it to stop operating altogether.<\/p>\n\n\n\nDo LED Landscape Lights Interfere With Garage Door Opener?<\/strong><\/h2>\n\n\n\n <\/figure>\n\n\n\nUnfortunately, your garage door opener can face interference by the LED lights inside the garage and the landscape lights installed outside your garage or on the driveway. The LED landscape lights not close to the garage door are not likely to cause the issue as the radio wave of those lights will not be as strong near the garage door opener device.<\/p>\n\n\n\n
The reason why LED landscape lights interfere with garage door openers is the same as why LED garage lights interfere with the door opener. Let us learn the same in the next section of the article.<\/p>\n\n\n\n
How Do LED bulbs Interfere With Garage Door Openers?<\/strong><\/h2>\n\n\n\n <\/figure>\n\n\n\nA garage door opener operates on a circuit that includes the mechanism to open and close the garage door. The circuit also has a receiver that allows the user to operate the garage door opener using the remote or the linked vehicle through radio waves.<\/p>\n\n\n\n
On the other hand, LED lights flash about 10-15 times per second, creating a small amount of radio noise. The LED light frequency creates a compatibility issue between the light and the garage door opener as radio waves are susceptible to interference. The interference may be created by either your indoor LED garage lights or landscape LED lights.<\/p>\n\n\n\n
While most LED light bulbs have shielding to prevent the noise from spreading, some don’t. The circuit’s wiring often amplifies the issue as it boosts the radio signal. The LED light radio waves interfere with the door opener signal and mask it, preventing the garage door from opening and closing on your instruction. As a result, your garage door will either get stuck or move slowly. If your LED lights block your garage door opener’s electronic frequency, the door may not operate at all.<\/p>\n\n\n\n
Solution For LED Interference With Garage Door Opener<\/strong><\/h2>\n\n\n\nFacing difficulties communicating with your garage door due to LED lights can be frustrating, but You can resolve the issue. There are three ways to prevent your LED lights from interfering with the garage door opener so you can operate your garage door without any hiccups or hassle. In this section of the article, we will walk through all three ways.<\/p>\n\n\n\n <\/figure>\n\n\n\nInstalling An LED Light That Blocks Radio Wave Interference<\/strong><\/h3>\n\n\n\n <\/figure>\n\n\n\nThe cheaper LED manufacturers do not use the shielding that cuts back on the interference of the LED light with other appliances like garage door openers or wifi routers. Hence, the lights interfere with the functioning of the appliances leaving the user distressed. But you can resolve the issue in minutes if you shed some extra money investing in the LED lights that block radio wave interference. <\/p>\n\n\n\n
Both the LED lights and the garage door openers operate on around 28-360 MegaHertz causing them to interfere with one another. Federal Communications Commission (FCC) compliant LED light bulbs that block radio wave frequency are well shielded and ensure that there is no frequency interference with other appliances.<\/p>\n\n\n\n
Shielding The LED Light Wiring<\/strong><\/h3>\n\n\n\n <\/figure>\n\n\n\nThis method is a time-consuming solution for LED interference with garage door openers <\/strong>but is an effective one. Shielding the LED light wires would ensure suppressing the extra noise that the cables generate so that no radio wave interference takes place with the garage door. You can either replace the existing wires with the shielded wires or add tubes to the existing wires to shield them from interference. <\/p>\n\n\n\nSince tubing the wiring means sliding the shielding tube over the wires, I strongly advise disconnecting the power supply before initiating the process. Once the shielding process is done, your LED lights will no longer interfere with the garage door opener, and you should be able to operate the door without any trouble.<\/p>\n\n\n\n
Adding Ferrite Beads On The LED Light Wiring<\/strong><\/h3>\n\n\n\n <\/figure>\n\n\n\nThe more straightforward and accessible way to prevent led lights from interference with garage door openers<\/strong> is using ferrite beads. A ferrite bead is a passive electronic component that suppresses the high-frequency signals on a power supply line. You must have noticed these cylindrical beads on various appliances like your laptop chargers.<\/p>\n\n\n\nSince most radio frequency boost happens on the LED light wiring rather than on the LED lights themselves, you can simply plug a ferrite bead on the negative cable of the wiring as close as possible to the fixture. The bead will suppress the extra noise that the cables are generating, allowing you to prevent your LED lights from interfering with the garage door opener. <\/p>\n\n\n\n
The best part about using ferrite beads is that they are easy to install, not expensive, and easily available.<\/p>\n\n\n\n
FAQs<\/strong><\/h2>\n\n\n\nQ1. Do LED lights affect wifi signals?<\/strong><\/p>\n\n\n\nAnswer – <\/strong>Though LED lights operate at a higher frequency than the wifi signals, it is possible for the wifi router to intercept some noise from LED lights. Hence, LED lights can affect wifi signals.<\/p>\n\n\n\nQ2. Are cheaper LED lights more susceptible to causing an interface with the garage door opener?<\/strong><\/p>\n\n\n\nAnswer – <\/strong>Yes, cheaper LED are more susceptible to causing inference with the garage door opener as they flicker a lot that a human eye cannot notice. Cheaper LED lights are also more prone to burning out frequently; hence, I do not recommend them. <\/p>\n\n\n\nQ3. How many lumens LED light is needed in a garage?<\/strong><\/p>\n\n\n\nAnswer – <\/strong>Installing 50 lumens per square foot of the garage area should provide you with a well-lit residential garage.<\/p>\n\n\n\nConclusion<\/strong><\/h2>\n\n\n\nLED lights have a significant advantage over other kinds of lighting solutions and are an incredible invention. Even garage door openers are a much-needed invention that has made our lives more comfortable than ever. But all the advantages of LED lights and garage door openers are in vain if your lights start interfering with your door opener. While it is frustrating to have your indoor LED garage lights or landscape LED lights interfere with your garage door opener radio frequency, you can resolve the issue easily. <\/p>\n\n\n\n
I hope the article about solving the issue of LED light interference with garage door openers would have helped you find a solution that works for you. If you have more questions, do write to me in the comment section.<\/p>\n","protected":false},"excerpt":{"rendered":"
… Read more<\/a><\/p>\n","protected":false},"author":4,"featured_media":6055,"comment_status":"open","ping_status":"open","sticky":false,"template":"","format":"standard","meta":{"_mi_skip_tracking":false,"footnotes":""},"categories":[1],"tags":[190,156],"yoast_head":"\nExplained: Do LED Lights Interfere With Garage Door Openers? - BringUpToDate<\/title>\n \n \n \n \n \n \n \n \n \n \n \n \n\t \n\t \n\t \n \n \n \n\t \n\t \n\t \n